Mitsubishi Electric Q13UDVCPU - Page 550

548
SD687
Standard
ROM write
count index
Write count
index up to
present
This register stores the index value of write count of the
standard ROM (flash ROM)
*1
up to the present in 32-bit
binary. When the index value exceeds 100 thousand times,
"FLASH ROM ERROR" (error code: 1610) occurs. (The index
value will be counted even after it exceeds 100 thousand.)
*1 The write count does not equal to the index value.
(Since the maximum write count of the flash ROM has
been increased by the system, 1 is added to the index
value when the total write data size after the previous
count-up reaches about 1M byte.)
S (At write) New
QnU
LCPU
SD688
SD689
Backup error
factor
Backup error
factor
This register stores the cause of an error that occurred during
backup.
•0
H
: No error
•100
H
: Memory card or SD memory card not inserted
•200
H
: Backup data size exceeded
•300
H
: Write protection set to memory card or SD memory
card
•400
H
: Memory card or SD memory card write error
•500
H
: Backup data read error (program memory)
•503
H
: Backup data read error (standard RAM)
•504
H
: Backup data read error (standard ROM)
•510
H
: Backup data read error (system data)
•600
H
: Backup preparation was performed while latch data
was being backed up to the standard ROM.
•601
H
: Backup preparation was performed during online
change.
•602
H
: Backup preparation was performed with an FTP
client connected to and communicated with the CPU
module.
•603
H
: Backup preparation was performed while the data
logging function was being executed.
•605
H
: Backup preparation was performed while the project
data batch save/load function was being executed.
•606
H
: Backup preparation was performed while any
specified file or folder was being deleted using a display
unit.
•607
H
: Backup preparation was performed while the iQ
Sensor Solution function (data backup/restoration) was
being executed.
•608
H
: Backup preparation was performed while the file
transfer function (FTP client) was being executed.
•609
H
: Backup preparation was performed while the CPU
module data backup/restoration function was being
executed.
•700
H
: A security key is set to the CPU module.
•701
H
: Backup preparation was performed when "Execution
Program Protection Setting" was enabled with a block
password.
S (Error) New
QnU
*1
LCPU
SD690
Backup
status
Backup
status
Stores the current backup status.
• 0: Before backup
• 1: Being prepared
• 2: Ready
• 3: Being executed
• 4: Completed
• FF: Backup error
S (Status
change)
New
QnU
*1
LCPU
SD691
Backup
execution
status
Backup
execution
status display
(percentage)
• This register stores the progress of backup to the memory
card or SD memory card in percentage (0 to 100%).
• "0" is stored at the start of backup.
S (Status
change)
New
QnU
*1
LCPU
Number Name Meaning Explanation
Set by
(When Set)
Corresponding
ACPU
D9
Corresponding
CPU