56
(c) QnUDE(H)CPU
*1 Format ATA cards by a programming tool only. ( Page 240, Section 9.3)
*2 For the writing method to a memory card and USB cables, refer to the following.
Operating manual for the programming tool used
*3 For the GX Works2, GX Developer and GX Configurator versions that can be used with the Universal model QCPU,
refer to Page 634, Appendix 5.1.
*4 Use the following Ethernet cables
• For 10BASE-T connection: Cables compliant to Ethernet standards, category 3 or higher (STP/UTP cables (In an
environment subject to electric noise, use shielded twisted pair (STP) cables.))
• For 100BASE-TX connection: Cables compliant to Ethernet standards, category 5 or higher (STP cables)
Universal model QCPU
Memory card
*1
Memory card
*1
PC card
adapter
Personal Computer
(GX Works2, GX Developer,
GX Configurator)
*3
Ethernet cable
*4
USB cable
(Connector type miniB)
*2
To Next Page
Loading...
