65
CHAPTER 4 INSTALLATION AND WIRING
4
4.2 Mounting a Module
4.2.2 Base unit installation
(2) Mounting a base unit on a DIN rail
Note the following when mounting a DIN rail.
Mounting a DIN rail needs special adaptors (optional), which are user-prepared.
(a) Applicable adaptor types
(b) Adaptor installation method
The following figures show how to attach adaptors for mounting a base unit on a DIN rail.
(c) Applicable DIN rail types (IEC 60715)
TH35-7.5Fe
TH35-7.5Al
TH35-15Fe
For Q38B, Q312B, Q68B, Q612B, Q38RB, Q68RB,
Q65WRB, Q38DB, Q312DB : Q6DIN1
For Q35B, Q35DB, Q65B, Q00JCPU, Q00UJCPU : Q6DIN2
For Q33B, Q52B, Q55B, Q63B, Q32SB, Q33SB, Q35SB : Q6DIN3
DIN rail mounting
adaptors
Quantity of included parts
Adaptor(Large) Adaptor(small)
Mounting screw
(M5 × 10)
Square washer Stopper
Q6DIN1 2 4 3 3 2
Q6DIN2 2 3 2 2 2
Q6DIN3 1 2 2 2 2
Base unit rear
Place the hook of the adaptor
(small) in the lower hole.
Push the top of the adaptor
(small) far enough until it
"clicks".
Insert the adaptor (large) into the grooves of
the base unit from below.
Push the bottom of the adaptor (large) far enough
until it "clicks".
To Next Page
Loading...
