12
TROUBLESHOOTING
12.2 Troubleshooting Flowchart
12.2.6 When the "RUN" LED flashes
12 - 10
9
EMC AND LOW
VOLTAGE
DIRECTIVES
10
LOADING AND
INSTALLATION
11
MAINTENANCE AND
INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
12.2.6 When the "RUN" LED flashes
If the "RUN" LED flashes, follow the steps below.
When the programs or parameters are written into the CPU module during STOP status
and then the RUN/STOP/RESET switch is set from STOP to RUN, the "RUN" LED of the
CPU module flashes.
Although this status does not mean the CPU module error, the CPU module stops the
operation. To set the CPU module into RUN status, reset the CPU module using the RUN/
STOP/RESET switch.
With this setting, the "RUN" LED turns on.
The "RUN" LED still flashes even when the RUN/STOP/RESET switch is set from RUN to
STOP and then to RUN after flashing.
To Next Page
Loading...
