Mitsubishi Electric QS001CPU - 2.2 Configuration of Peripheral Devices

2
SYSTEM CONFIGURATION
2.2 Configuration of Peripheral Devices
2.1.1 Precautions for system configuration
2 - 5
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
GENERAL SPECIFICATIONS
4
CPU MODULE
5
POWER SUPPLY MODULE
6
BASE UNIT
7
BATTERY
8
CPU MODULE START- UP PROCEDURES
2.2 Configuration of Peripheral Devices
This section describes the configuration of the peripheral devices usable in the safety
programmable controller system.
* 1: For details of the USB cable, refer to "About the USB cable (QCPU (Q mode) compatible)" of the
following manual.
GX Developer Operating Manual
Figure 2.3 Configuration of peripheral devices
Personal computer
(GX Developer Version 8.40S or later)
USB cable*1
QS001CPU