Mitsubishi Electric SW1DNC-MESIF-E - Page 226

7 - 68
7.10 Job Setting
7.10.2 Setting items in Trigger conditions
7
MES INTERFACE FUNCTION CONFIGURATION TOOL
(Example)
The following shows that the job is activated when the value of the tag
component (Process 1, Temperature) reaches 45 or higher.
(Example)
To activate the job repeatedly while the condition of [Value monitoring startup]
is met, Make settings as follows:
As the condition alternates between true and false as shown below, job startup
can be repeated while the [Value monitoring startup] condition is met.
Figure 7.52 [Value monitoring startup] setting example 1
Table 7.52 [Value monitoring startup] setting example 2
Item Description
Combination [AND]
Trigger 1, Trigger 2 [Value monitoring startup], [Specified time period startup]
Figure 7.53 Job startup points when [Value monitoring startup] and [Specified time period startup] are
combined
Sampling interval
Condition value
False
True
False
True
Startup point
False
True
Fixed cycle
Timing when AND is used
Timing of [Value monitoring startup]
Timing of [Specified time period startup]
Combined by AND
[Trigger 1]
[Trigger 2]
Tag component value