7
MES INTERFACE FUNCTION CONFIGURATION TOOL
7.13 Online - Remote operation
7.13.4 Changing the job status
7 - 141
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETTINGS AND
PROCEDURE TO
OPERATION
5
INSTALLATION AND
UNINSTALLATION
6
FUNCTIONS
7
MES INTERFACE
FUNCTION
CONFIGURATION TOOL
8
DB CONNECTION
SERVICE AND
SETTING TOOL
7.13.4 Changing the job status
The job status can be changed.
The job status changed by this operation returns to the status set in [Job settings]
by performing any of the following operations.
• Perform [Update settings]
Section 7.13.2 (3) Update settings
• Power OFF and then ON
• Reset the programmable controller CPU
1 From [Job List], select the job whose status is to be changed.
2 Select a checkbox of the status to be changed.
Figure 7.109 [Change job status]
Table 7.96 Selection items of [Change job status]
Item Description
Enable job
• Checked
The job is enabled and thereby it is executed when the trigger
conditions are met.
• Not checked
The job is disabled, and thereby it is not executed even if the
trigger conditions are met.
Enable startup logging
*1
• Checked
The startup logging is enabled, and thereby startup records are
logged.
• Not checked
The startup logging is disabled, and thereby startup records are
not logged.
Enable detailed logging
*2
• Checked
The detailed logging is enabled, and thereby detailed records are
logged.
• Not checked
The detailed logging is disabled, and thereby detailed records are
not logged.
Disable writing to PLC
device
• Checked
Writing to programmable controller devices is disabled.
• Not checked
Writing to programmable controller devices is enabled.
Disable writing to database
• Checked
*3
Writing to the database is disabled.
• Not checked
Writing to the database is enabled.
To Next Page
Loading...
