Mitsubishi A1SD75M3

6 - 17
MELSEC-A
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
<Speed change command pulse>
<Speed change command hold>
<New speed value setting>
<Speed change request setting>
<Speed change write>
<Speed change result read>
<Speed change command storage OFF>
*
*
*
No.14 Speed change program
*
*
*
No.15 Override program
*
*
*
No.16 Acceleration / deceleration time change program
<Acceleration / deceleration time
change program command pulse>
<Setting of acceleration time to 2000ms>
<Setting of deceleration time to without change(0)>
<Acceleration / deceleration time write>
<Acceleration / deceleration time change
enable write>
<Acceleration / deceleration time change
disable write>
<Torque change command pulse>
<Setting of torque output setting value>
<Torque output setting value write>
*
*
*
No.17 Torque change program
<Override command pulse>
<Override value setting>
<Override value write>