Mitsubishi A2CCPU - Page 60

4. A2ccPu /MELSEC-A
(3) Operation procedure
(a) To set the A2CCPU in the offline state, set the offline switch
with a peripheral device.
(b) To return the AZCCPU back from the offline state to the
online state, use either of the following
two methods.
1) Reset the offline switch setting with a peripheral device.
2) Reset the A2CCPU with the RUN key-switch.
POINT I
(1) Devices set in the offlie state cannot be turned
ON/OFf with a sequence program.
The devices set in the offline state during testing, must
be returned to the online state by resetting the offline
switch after the completion of test operation.
(2) The devices returned from the offtine state to the
online state can be turned OWOFF with a peripheral
device.
Before returning thew devices to the online state,
check the input conditions of an OUT instruction.
Return to the online
state &or making sure that no
problems
will arise when the devices are returned to
the online
state.
'? '- .'
1
1
d
1
J
m