Mitsubishi A2CCPU - 4.6 Instructions

4. A2CcPU /MELSEC-A
4.6 INSTRUCTIONS
4.6.1 Sequence instructions
Master control
instructions
Contents of Rdng
I I
Logical operation start (NO contact operation start)
wl +- Logical NOT operation start (NC contact operation start)
Logical product (NO contact series connection)
Logical product
NOT (NC contact series connection)
/ANI]
v] I I :: I I
Logical add (NO contact parallel connection)
IT] I :: 1
Logical add NOT (NC contact parallel connection)
I ANDs logical blocks. (Series connection of blocks) 0
7,--+----+--
L-4F-J L+d
[TI --p------ ---_- il-' ''?--- ORs logical blocks. (Parallel connection of blocks)
w1
Stores the operation result.
3'*'h:-:j
Reads the operation rasult from MPS.
Reads the operation result from MPS and clears the result.
Device output
piq+SETI@H Device set
-1 4 RST I @ Device reset
4 PLS I @ Generates one-program cycle pulses on the leading edge of input signal
~I~PLFI@~ Generates one-program cycle pulses on the trailing edge of input signal
[SFTI 4 SFf I @ H
TI
4 sm I @H
Shifts device 1 bit
7
Master control reset
4 MCR I n H
MCR]
Master control start
4 MC I n I @ H
Toble 4.11 Sequence Instructions (Continue)
I
P
d
c
I
1
3
3
1
-' 3
'?
7
4-56 J
I8 INAI 66238A