Mitsubishi City Multi PURY-P400 - Deleting Registration Information

–37–
2) Method of retrieval/confirmation
• Retrieval/confirmation of group registration information on indoor unit............... 2
The address of the indoor unit registered on the remote controller is displayed.
[Operation procedure]
1 With the remote controller under stopping mode or with “HO” displayed on the LED, press and hold the
FILTER
+
buttons (A + B) simultaneously for 2 seconds to switch to the registration mode.
2 In order to confirm the indoor unit address already registered, press button (E). (See figure below.) When a group of
multiple units is registered, the addresses will be displayed one at a time in order at each pressing of button (E).
3 After completing the registration, press and hold the
FILTER
+ buttons (A + B) simultaneously for 2 seconds
to return to the original mode (with the remote controller under stopping mode).
• Retrieval/confirmation of registration information ................................................ 3
The registered information on a certain unit (indoor unit, outdoor unit, remote controller or the like) is displayed.
[Operation procedure]
1 With the remote controller under stopping mode or with “HO” displayed on the LED, press and hold
FILTER
+
buttons (A + B) simultaneously for 2 seconds to switch to the registration mode.
2 Operate button (G) for the interlocked setting mode. (See figure below.)
3 Assign the unit the desired registration address and confirm using this (TIMER SET) button (H). Then press
the
button (E) to display it on the remote controller. (See figure below.)
Each pressing of button (E) changes the display of registered content. (See figure below.)
4 After completing the retrieval/confirmation, press and hold the
FILTER
+ buttons (A + B) simultaneously for
2 seconds to return to the original mode (with the remote controller under stopping mode).
• Registration Completed
• Registration Failed
ERROR CODE
OA UNIT ADDRESS NO
˚C
ERROR CODE
OA UNIT ADDRESS NO
˚C
▲
▼
1 Press the button for confirmation (E)
Note: No matter how often the button is
pressed if only one address is
registered only one address will be
displayed.
Indicates the type of unit
(Indoor unit in this case)
1
1
ON/OFF
TEMP
FILTER
CHECK TEST
ON OFF
CLOCK
PAR-F27MEA
TIMER SET