1Error list
Error no. H264n
1-34
H264n
(n indicates the
axis number (1
to 8))
Error message Add axis FLS signal is input
Cause Add axis FLS signal is input
Measures Release the brake and move the arm by hand. Or, referring to "Operation to Temporarily Reset an Error
that Cannot Be Canceled" in the separate volume "Instruction Manual/Detailed Explanation of Functions
and Operations", reset the error and move the axis "n" within the operation range using JOG operation.
H265n
(n indicates the
axis number (1
to 8))
Error message Add axis RLS signal is input
Cause Add axis RLS signal is input
Measures Release the brake and move the arm by hand. Or, referring to "Operation to Temporarily Reset an Error
that Cannot Be Canceled" in the separate volume "Instruction Manual/Detailed Explanation of Functions
and Operations", reset the error and move the axis "n" within the operation range using JOG operation.
L2660 One of the errors below is detected.
Please take measures corresponding to an error message.
Error message Error concerning axis coop
Cause The error concerning the axis coop occurred
Measures Please Confirm the content by a detail number of the error
Error message Illegal robot No.(axis trk)
Cause The designated robot No. is illegal
Measures Set the correct robot No.
Error message Illegal axis No.(axis trk)
Cause The designated axis No. is illegal
Measures Set the correct axis No.
Error message Illegal unit system (axis trk)
Cause A rotary axis is designated
Measures Please designate a linear drive axis
Error message Origin unsetting (axis trk)
Cause Axis tracking cannot be executed because of origin unsetting
Measures Please set the origin and turn the power OFF and ON
Error message Illegal robot No.(base coop)
Cause The designated robot No. is illegal
Measures Set the correct robot No.
Error message Illegal axis No.(base coop)
Cause The designated axis No. is illegal
Measures Set the correct axis No.
Error message Illegal unit system (base coop)
Cause A rotary axis is designated
Measures Please designate a linear drive axis
Error message Origin unsetting (base coop)
Cause Base coop cannot be executed because of origin unsetting
Measures Please set the origin and turn the power OFF and ON
Error No. Error cause and measures
To Next Page
Loading...
