MANUAL TRANSMISSION (E-W) -
Input Shaft <F5MR3>
22A-8-2
PWEE9508
E
May 1995Mitsubishi Motors Corporation
REASSEMBLY SERVICE POINTS
"
A
A
INPUT SHAFT BEARING/CLUTCH HOUSING END
INSTALLATION
(1) Locate the bearing on the input shaft.
(2) Tap the bearing with a drift until it abuts against the stop
on the input shaft.
"
B
A
INPUT SHAFT BEARING/TRANSMISSION CASE
END INSTALLATION
(1) Fit the shim.
NOTE
In t h e case of old bearings: Fit the old shim.
In the case of new bearings: fit a shim with a thickness
of 1.6 mm.
(2) Fit the bearing.
AddedPWEE9508-BMitsubishi Motors Corporation
May 1996
E
RMT0056
RMT0057
To Next Page
Loading...
Need help?
General
