126
Calibration parameters
2.13 Calibration parameters
2.13.1 Meter (frequency meter) calibration (C1 )
The parameter number in parentheses is the one for use with the parameter unit (FR-
PU04).
The AM terminal is factory-set to provide 5VDC output in the full-scale status of
each monitor item. However, calibration parameter C1 can be used to adjust the
output voltage ratio (gain) according to the meter scale. Note that the maximum
output voltage is 5VDC.
Parameter Name Factory Setting Setting Range Remarks
C1 (901)
AM terminal
calibration
Setting is enabled when
Pr. 30 = "1"
To Next Page
Loading...
