10
8 PARAMETER FUNCTIONS 8-1
8.1 Protection and Editing of the Parameters 8-6
8.2 Selection of the Operation Mode 8-8
8.3 Selection of the Speed Command 8-12
8.3.1 Selection of the analog speed command specifications................... 8-12
8.3.2 Variable-speed operation using contact input signals ...................... 8-18
8.4 Selection of the Control Circuit Contact Input Terminal Functions
8-21
8.5 Setting of the Operation Pattern 8-24
8.5.1 Running speed region...................................................................... 8-24
8.5.2 Acceleration time and deceleration time .......................................... 8-26
8.5.3 Acceleration/deceleration patterns................................................... 8-28
8.5.4 Stopping operation........................................................................... 8-29
8.5.5 Selection of regenerative brake unit................................................. 8-30
8.5.6 Stall prevention operation level........................................................ 8-31
8.5.7 Selection of motor tone.................................................................... 8-32
8.5.8 Other settings .................................................................................. 8-32
8.6 Setting of Various Operation Methods 8-34
8.6.1 JOG operation ................................................................................. 8-34
8.6.2 Communication operation from the PU connector............................ 8-35
8.6.3 PID control operation....................................................................... 8-45
8.6.4 Alarm retry operation ....................................................................... 8-52
8.6.5 Power failure deceleration-to-stop operation.................................... 8-54
8.7 Monitoring of Operation Status 8-55
8.7.1 Selection of operation panel display data......................................... 8-55
8.7.2 Selection of the control circuit output terminal functions................... 8-58
8.7.3 Detection of running speed.............................................................. 8-61
8.7.4 Detection of output current............................................................... 8-63
8.7.5 Selection of the instrument connection terminal functions................ 8-64
8.8 Control Parameters 8-67
APPENDIX 1 PARAMETER LIST (NUMERICAL ORDER) 8-69
Get other manuals https://www.bkmanuals.com
To Next Page
Loading...
