Mitsubishi MELIMP Series

8 PARAMETER FUNCTIONS
8-4
8.6 Setting of Various Operation Methods 8-34
8.6.1 JOG operation ................................................................................. 8-34
Pr. 15 "JOG speed"
Pr. 16 "JOG acceleration/deceleration time"
8.6.2 Communication operation from the PU connector............................ 8-35
Pr. 117 "station number"
Pr. 118 "communication speed"
Pr. 119 "stop bit length/data length"
Pr. 120 "parity check presence/absence"
Pr. 121 "number of communication retries"
Pr. 122 "communication check time interval"
Pr. 123 "waiting time setting"
Pr. 124 "CR-LF presence/absence selection"
8.6.3 PID control operation....................................................................... 8-45
Pr. 128 "PID action selection"
Pr. 129 "PID proportional band"
Pr. 130 "PID integral time"
Pr. 131 "upper limit"
Pr. 132 "lower limit"
Pr. 133 "PID action set point for PU operation"
Pr. 134 "PID differential time"
8.6.4 Alarm retry operation ....................................................................... 8-52
Pr. 65 "retry item selection"
Pr. 67 "retry count selection"
Pr. 68 "retry time selection"
Pr. 69 "retry count display"
8.6.5 Power failure deceleration-to-stop operation.................................... 8-54
Pr. 261 "power failure stop selection"
Pr. 262 "subtracted speed at deceleration start"
Pr. 263 "subtraction starting speed"
Pr. 264 "power-failure deceleration time 1"
Pr. 265 "power-failure deceleration time 2"
Pr. 266 "power-failure deceleration time switch-over speed"
Get other manuals https://www.bkmanuals.com