A
Anna EdwardsSep 1, 2025
How do I resolve the issue of a specified digital value being outside the range on my Mitsubishi MELSEC Q Controller?
- AAaron ThomasSep 2, 2025
Set a value that is within the range.
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...How do I resolve the issue of a specified digital value being outside the range on my Mitsubishi MELSEC Q Controller?
Set a value that is within the range.
How do I fix setting outside the output range on Mitsubishi Controller?
Reset to the correct parameter with GX Developer parameter setting.
What to do if more than one channel was set at the same time during offset/gain settings on Mitsubishi MELSEC Q Controller?
Set the correct value in offset/ gain setting mode (Un\G22, Un\G23).
What should I do if the value set to the G(P).OGLOAD instruction, G(P).OGSTOR instruction or save data classification setting is outside the range on Mitsubishi MELSEC Q Controller?
Set the value within the range.
General| Series | MELSEC Q Series |
|---|---|
| Type | Modular PLC |
| Programming Software | GX Works2, GX Works3 |
| Category | Programmable Logic Controller (PLC) |
| I/O Modules | Digital I/O, Analog I/O, High-Speed Counter, Positioning |
| Communication | Ethernet, CC-Link |
| Programming Languages | Ladder Logic, Structured Text, Function Block Diagram, Sequential Function Chart, Instruction List |
| Memory | Flash Memory |
| I/O Points | Up to 4096 points (expandable with additional modules) |
| Power Supply | AC or DC power supply options available, depending on the base unit and modules. |
| Mounting | DIN rail mounting |
| Operating Temperature | 0°C to 55°C |
| Storage Temperature | -25°C to 75°C |
| Humidity | 5% to 95% (non-condensing) |
| Vibration Resistance | 10 to 57 Hz, 0.075mm amplitude |
| Weight | Varies depending on the module, from a few grams to several kilograms. |
| Shock Resistance | 147 m/s² (3 times each in X, Y, Z directions) |
