1
Remove the front panel and
pre-filter.
2
Remove the air filter.
3
Soak the air filter in water.
Do not use detergent or hot water.
Also, do not brush or rub while
soaking as this may damage the filter.
• Stains may remain on the filter, but should not
affect performance.
• The filter can be soaked for a total of eight
times.
After that, replace with a new filter.
Once every three months
Air filter
Front panel
Soak the filter in water about once every three months.
For maintenance procedures see
10
Soak in cool to
lukewarm water for 30
minutes.
Maintenance (Cont.)
4
Dry the air filter.
Do not hang with pegs as this may
damage the filter.
Do not use the filter while wet.
5
Fit the air filter.
With the strips facing up, set the air
filter inside the tabs on the pre-filter.
6
Attach the pre-filter and front
panel.
Pre-filter
1 Remove by holding
the bottom.
2 Remove by
holding the
tabs.
Performance is
unaffected even if the
metal fins inside the main
unit are slightly bent.
Air filter
Pre-filter
Tabs (6)
1 Attach by holding
the tabs.
2 Hook the top edge
to the top part of
the unit and push
the bottom in.
To Next Page
Loading...
Need help?
General
