To Next PageTo Next PageWhat causes undervoltage on Mitsubishi MR-J4-60A Amplifier?
Undervoltage in your Mitsubishi Amplifier can be due to: * Voltage drop in the control circuit power. * Voltage drop in the main circuit power.
Why is my Mitsubishi MR-J4-60A Amplifier showing a servo motor overheat error?
A servo motor overheat error in your Mitsubishi Amplifier can be due to: * Abnormal temperature of servo motor 1. * Abnormal temperature of servo motor 2. * Thermistor disconnected error. * Abnormal temperature of servo motor 3. * Abnormal temperature of servo motor 4.
What causes a main circuit error in my Mitsubishi MR-J4-60A Amplifier?
A main circuit error in your Mitsubishi Amplifier can occur due to: * A ground fault detected by the hardware detection circuit. * A ground fault detected by the software detection function.
What causes an overspeed error on a Mitsubishi MR-J4-60A?
An overspeed error on your Mitsubishi Amplifier is caused by abnormal motor speed.
General| Model | MR-J4-60A |
|---|---|
| Rated Output | 0.6 kW |
| Position Control | Yes |
| Speed Control | Yes |
| Torque Control | Yes |
| Full-closed control | Yes |
| Advanced One-touch Tuning | Yes |
| Real-time adaptive tuning | Yes |
| Vibration Tough Drive | Yes |
| Machine Resonance Suppression Filter | Yes |
| STO | Yes |
| SS1 | Yes |
| Type | Servo Amplifier |
| Voltage Class | 200 V |
| Control Method | Sine Wave PWM Control |
| Interface | USB, RS-422/485 |
| Ambient temperature | 0 to 55 °C (32 to 131 °F) |
| Vibration resistance | 5.9 m/s2, 10 to 55 Hz |
