Mitsubishi Outlander 2015 - Page 258

To activate
E00633600016
Accelerate or decelerate to your desired
speed, and push down the SET - switch (B).
the Speed Limiter memorizes the current ve-
hicle speed when you release the SET -
switch (B). Now, the Speed Limiter starts
controlling in order not to exceed the set
speed.
If the current vehicle speed is lower than
about 30 km/h (19 mph) (settable minimum
speed), the set speed is set at about 30 km/h
(19 mph).
The set speed is displayed in the combination
meter.
And, control state “LIMIT” is displayed in
the combination meter.
mono-colour liquid crystal display
colour liquid crystal display
To increase the set speed
E00633700017
By using the RES + switch
E00633800018
Push up the RES + switch continuously.
Then the set speed displayed in the combina-
tion meter is gradually increased.
If the set speed reaches your desired speed,
release the RES + switch (C).
The set speed is increased each about 5 km/h
(3 mph) per about 0.5 second.
If a driver wants to increase the set speed a
little, push up RES + switch for less than
about 0.5 second and release it.
The set speed is increased 1 km/h (1 mph)
each taps.
By using the CANCEL switch,
the accelerator pedal and the
SET - switch
E00633900019
Press the CANCEL switch (D) to deactivate
the Speed Limiter.
Control state “LIMIT” is disappeared and
change control state “LIMIT OFF” in the
combination meter.
Speed Limiter*
6-76
OGFE16E1
Starting and driving
6