ALTERNATOR AND IGNITION SYSTEM
ENGINE OVERHAUL
11B-12
5. Apply an appropriate and minimum amount of
engine oil to the threaded portion of the crankshaft
and lower part of the flange.
6. With the chamfered side on the inside of the
washer facing the bolt top, install the crankshaft
pulley washer to the crankshaft pulley centre bolt.
7. Tighten the crankshaft pulley centre bolt to the
specified torque of 210 N
⋅m.
>>C<< ALTERNATOR INSTALLATION
AKC00006
1
2
AB
1. Temporarily tighten alternator bolt and nut.
2. First tighten the upper mounting bolt to the
specified torque, and then tighten the lower nut.
Specified torque: 44 ± 10 N⋅m
To Next Page
Loading...
Need help?
General
