Mitsubishi OUTLANDER Service Manual

EXHAUST MANIFOLD
ENGINE OVERHAUL
11B-18
REMOVAL SERVICE POINTS
<<A>> OXYGEN SENSOR REMOVAL
AC301966
AB
MB991953
Oxygen sensor
Remove the connection and clamp of oxygen sensor
connector, and then use special tool oxygen sensor
wrench (MB991953) to remove the oxygen sensor.
INSTALLATION SERVICE POINTS
>>A<< EXHAUST MANIFOLD INSTALLA-
TION
AKB00880
12
AB
345
1. Tighten the exhaust manifold nut to the specified
torque of 49
± 5 N⋅m in the order shown in the
illustration.
>>B<< OXYGEN SENSOR INSTALLATION
CAUTION
•
AC301966
AB
MB991953
Oxygen sensor
Do not use a sensor that has fallen down.
Tighten the oxygen sensor to the specified torque by
using special tool oxygen sensor wrench
(MB991953).
Tightening torque: 44 ± 5 N⋅m
>>C<< CRANK ANGLE SENSOR / O-RING
INSTALLATION
CAUTION
• Do not apply a force such as torsion or twist
to the O-ring during assembly of the sensor.
• Assemble the sensor, taking care not to give a
shock to it.
• Do not use a sensor that has fallen down.
Tighten the crank angle sensor to the specified
torque of 11
± 1 N⋅m.
>>D<< EXHAUST MANIFOLD BRACKET
INSTALLATION
CAUTION
The exhaust manifold gasket, washers and nuts
must not be reused.
1. After temporarily tightening the exhaust manifold
bracket with the installation bolts, check the
exhaust manifold fastens securely to the cylinder
block.
2. Tighten the cylinder block side bolt to the
specified tightening torque.
Tightening torque: 41 ± 10 N⋅m
AKC00009
Crank angle sensor cover
Exhaust manifold bracket
AB
3. Tighten the exhaust manifold side bolt to the
specified tightening torque.
Tightening torque: 56 ± 8 N⋅m

Mitsubishi OUTLANDER Specifications

General

Brand	Mitsubishi
Model	OUTLANDER
Category	Automobile
Language	English