Mitsubishi OUTLANDER Service Manual

CYLINDER HEAD AND VALVES
ENGINE OVERHAUL
11B-39
>>B<< RETAINER LOCK INSTALLATION
AK502741
AC
MB992089
MD998735
Use a special tool to compress the valve spring and
to install the retainer lock.
• Valve spring compressor (MD998735)
• Retainer holder C (MB992089)
>>C<< CYLINDER HEAD GASKET /
CYLINDER HEAD ASSEMBLY
INSTALLATION
AK602902AC
Top face of cylinder block
Degrease
Degrease
Bottom face of cylinder head
1. Completely remove the liquid gasket on the upper
plane of the cylinder block and the lower plane of
the cylinder head.
CAUTION
Sufficiently check that there is no residual oil on
the place where degreasing is performed. If fin
-
gerprints are left, do not touch it with bare hands
after the degreasing, since the oils from your fin
-
gers will harm the seal ability.
2. Degrease the place specified in the illustration.
AK602942AC
Ø 2 to Ø3 mm
Timing chain side
3. As shown in the illustration, apply a 2.5 ± 0.5 mm
of sealant to the top face of cylinder block.
Specified sealant:
ThreeBond 1217G or equivalent
4. Install the cylinder head gasket.
NOTE: Check that the centre of the liquid gasket
is located toward the cylinder gasket in the posi
-
tion specified in the illustration.
5. As shown in the illustration, apply a 2.5 ± 0.5 mm
of sealant to the top face of cylinder head gasket.
Specified sealant:
ThreeBond 1217G or equivalent
6. Install the cylinder head assembly.
>>D<< CYLINDER HEAD BOLT
INSTALLATION
1. Install new cylinder head bolts and washers in the
following procedure.
NOTE: Cylinder head bolts and washers must not
be reused.
2. Apply an appropriate amount of engine oil to top
and bottom surfaces of washers and threaded
portion of bolts.
3. Install cylinder head bolts to the cylinder head.

Mitsubishi OUTLANDER Specifications

General

Brand	Mitsubishi
Model	OUTLANDER
Category	Automobile
Language	English