Chapter 2 Part B 2.OL and 2.4L four-cylinder engines
26-17
18.8a Engine mount details (typical 2WD model)
I Front insulator
3 Heat protector
5 Rear insulator
2 Insulator stopper 4 Number 2 crossmember
.
1 Front insulator
2 Insulator stopper
3 Heatprotector
18.8b Engine mount details on a 4WD pick-up
4 Number 2 crossmember
7 Stopper
5 Heat protector
8 Transfer mounting bracket
6 Rear insulator
9 Transfer support insulator
10 Plate assembly
I.1 Transfer support bracket
3 Raise the vehicle and support it securely on jackstands, then position the center. Check that the rod on the front mount is not bent.
a jack under the engine oil pan. Place a large block of wood between the 5 Check for relative movement between the mount plates and the en-
jack head and the oil pan, then carefully raise the engine just enough to gine or frame (use a large screwdriver or pry bar to attempt to move the
take the weight off the mounts.
Warning:
DO NOTplace anypatiofyour mounts). If movement is noted, lower the engine and tighten the mount
body under the engine when it’s supported only by a jack! fasteners.
4 Checkthe mounts to see if the rubber is cracked, hardened or sepa-
6 Rubber preservati.ve may be applied to the mounts to slow deteriora-
rated from the metal backing. Sometimes the rubber will split right down
tion.
To Next Page
Loading...
