~~_. - ..-- -.
28-18 Chapter 2 Part B 2.OL and 2.4L four-cylinder engines
18.8~ Be sure to align the locating boss and hole in the
engine mount,
Replacement
Refer to illustrations 18.8a. 18.8b and 18.8~
7 Disconnect the negative battery cable from the battery, then raise the
vehicle and support it securely on jackstands (if not already done).
8 Remove the fasteners and detach the mount from the frame and en-
gine (see illustrations). Do not disconnect more than one mount at a
time, except during engine removal.
9 Installation is the reverse of removal. Use thread locking.compound
on the mount bolts and be sure to tighten them securely.
To Next Page
Loading...
