Mitsubishi Pick-Up 1987 User Manual

Chapter 2 Part A 2.6L four-cylinder engine
Contents
Camshaft - removal, inspection and installation .............. 13
Camshaft oil plug - replacement ......................... 11
Compression check ........................ :. See Chapter 2D
Crankshaft front oil seal - replacement ..................... 12
Cylinder head - removal and.installation .................... 14
Drivebelt check, adjustment and replacement ....... See Chapter 1
Engine mounts-check, replacement and asustment .........
19
Engine oil and filter change ........ -)r ............. See Chapter 1
Engine overhaul -general information ........... See Chapter 2D
Engine - removal and installation ............... See Chapter 2D
Exhaust manifold - removal and installation ................. 6
Flywheel/driveplate - removal and installation ............... 17
General information .............................. _ ..... 1
Intake manifold - removal and installation ................... 7
Oil pan - removal and installation ......................... 15
Oil pump - removal, inspection and installation ............... 16
Rear main oil seal - replacement .......................... 16
Repair operations possible with the engine in the vehicle ....... 2
Rocker arm assembly - removal, inspection and installation ..... 5
Silent shafts chain/sprockets - removal, inspection
and installation ...................................... 9
Spark plug replacement ........................ See Chapter 1
Timing chain and sprockets - removal, inspection
and installation .......... _ ............................ 10
Top Dead Center (TDC) for number one piston -locating ....... 3
Valve cover - removal and installation ...................... 4
Valves - servicing See Chapter 2D Valve spring,
retainer and seals - replacement ........................ 6
Specifications
General
Firingqrder ....... .._......._ .........................
Cylinder numbers (front-to-rear) ..........................
Bore ................................................
Stroke ......... .._ ...................................
Displacement .........................................
Camshaft
Endplay .. ..: ........................................
Runout ..............................................
Joumaldiameter.. .............................
.
..........
Bearing journal oil clearance ................................
Lobe height
1963 through 1966 pick-up ............................
1963 and 1964 Wlontero ............................. . .
1967 pick-up and 1965 through 1967 Montero .............
1966 on (all models) ..................................
Lobe wear (maximum), ...................................
Cylinder head warpage limit .......................
intake/exhaust manifold warpage limit ...........
Oil pump ,
Drive gear-to-bearing clearance
1963through1966
..................................
19670n ...........................................
l-3-4-2
l-2-3-4
3.59 inches
3.66 inches
155.9 cubic inches
0.004 to 0.006 inch
0.03 inch
1.339 inches
0.002 to 0.004 inch
1.6730 inch
1.6730 inch
1.6693 inch
1.6705 inch
0.020 inch
0.006 inch
0.006 inch per foot of manifold length
Cylinder location and
distributor rotation
0.0016 to 0.0026 inch
0.0020 to 0.0043 inch

Mitsubishi Pick-Up 1987 Specifications

General

Brand	Mitsubishi
Model	Pick-Up 1987
Category	Automobile
Language	English