Mitsubishi S6R2 - Case of Problems, and Conceivable Causes and Remedies; Table 11-1 the Starter Does Not Crank or Cranks; The Starter Does Not Crank or Cranks Slowly, Resulting in Start Failure

11-2
Chapter 11 TROUBLESHOOTING
Case of Problems, and Conceivable Causes
and Remedies
The Starter Does Not Crank or Cranks Slowly,
Resulting in Start Failure
Note: The table above also include the parts Mitsubishi Heavy Industries, Ltd. does not supply. For the parts Mitsub-
ishi Heavy Industries, Ltd. does not supply, inspect and maintain them following the manufacturer's operation
manual.
Table 11-1 The Starter Does Not Crank or Cranks Slowly, Resulting in Start Failure
Cause Remedies
Electrical
system
Faulty wire connection
Check the DC fuse.
Check wiring connection between battery, starter and starter
switch
Insufficiently charged battery
Check alternator. (Refer to P8-24)
Check and adjust belt. (Refer to P8-2)
Faulty battery
Check specific gravity of battery electrolyte. (Refer to P8-23)
Charge battery
Change battery.
Faulty starter or starter relay
Consult a dealer of Mitsubishi Heavy Industries, Ltd.
Lubricating
system
Oil viscosity too high Use appropriate engine oil. (Refer to P5-1)
Excessive oil
Check amount of engine oil and lubrication system. (Refer to P3-
9)
Basic engine
Rapid wear of sliding parts, or
locked
Consult a dealer of Mitsubishi Heavy Industries, Ltd.