Mitutoyo ABSOLUTE ID-F0550HENX - Page 24

12
2 Preparations before Use
No. 99MAH054A
■25.4 mm / 1 in and 50.8 mm / 2 in measuring range models
2
1
3
Lifting knob
Lifting knob cap
Upper edge of bushing
This product's cap
1 Rotatethecapcounterclockwisetoremoveitfromtheproduct.
2 Fixtheplunger,usingplierspaddedwitharag,etc.,sothatitdoesnot
turn,andtheninserttheliftingknobtothescrew(M2.5)ontheupper
edge of the plunger.
3 Turnthecapontheliftingknobtoxittotheupperedgeofthebushing.
Tips
• Store the removed cap to prevent loss.
• Do not remove the ring attached under the cap, and install the cap of the lifting
knob.
■12.7 mm / 0.5 in measuring range model
3
2
1
Cap
Screw
Lifting knob
1 Rotatethecapcounterclockwisetoremoveitfromtheproduct.