Mitutoyo ABSOLUTE ID-F0550HENX - Page 63

51
No. 99MAH054A
5 Setting Parameters
(Short press) / (Long press)
1 Pressthe[F2]key.
» Calculation function can be set.
2 Settingtheexecution/stopofthecalculationfunction
1 Press the [F1] key or [F3] key.
» Each time the key is pressed, it will switch execution/stop.
2 Press the [F2] key.
Whenexecution[on]isselected:
» The calculation function display (A) blinks and the previously set calculation
coe󰀩cientisdisplayed.
Tips
Ifthedisplayedcalculationcoe󰀩cientiscorrect,pressthe[F2]key.Calculation
coe󰀩cientisconrmed;shiftstothenextparameteritem.
When stop [oFF] is selected:
» Selectionisconrmed;shiftstothenextparameteritem.
(Go to "5.8 Selecting Analog Bar Display" on page 54.)
3 Settingthecalculationcoe󰀩cient
1 Press and hold the [F2] key.
» The sign will blink and can be changed.
» Continue to 3 if not changing the sign.
2 Press the [F1] key or [F3] key.
» Each time the key is pressed, it will switch the sign.
3 Press the [F2] key.
» Thesignisconrmedandtheneighboringdigitblinks.
4 Press the [F1] key or [F3] key.
» Each time the key is pressed, the value will change by one.
5 Press the [F2] key.
» Thenumberisconrmedandtheneighboringdigitblinks.
» Each time the key is pressed, the blinking digit moves to the right.
Repeat steps 4 to 5aboveuntilthenumbersforalldigitsareconrmed
(e.g.: -6.4641).
» Conrmingthelastdigitwillcausethecalculationfunctiondisplay(A)toblink.
6 Reconrmthenumericalvaluesetandpressthe[F2]key.
» Calculationcoe󰀩cientisconrmed;shiftstothenextparameteritem.
(Go to "5.8 Selecting Analog Bar Display" on page 54.)