5 External Input/Output Function
35
No. 99MBC109B
5
External Input/Output Function
This product is equipped with the following interfaces that enable the connection
of external equipment.
Interface
Parameter
setting
(No. 24)
Connectable equipment Functions
Digimatic
output
2 Digimatic Mini-Processor
(DP-1VR)
y
Printing the measurement
data, statistical calculation
results, etc.
USB 1 PC (for SENSORPAK)
y
Data output to a PC
RS-232C 0 PC, PLC
y
Data output to a PC, PLC
y
Control from external
system
I/O connector - Equipment such as a
switch or control unit
y
Data output to PLC
y
External control of
Counter
Tips
PLC: programmable logic controller
5.1
Digimatic Output Function
You can print the measurement data by connecting to a Digimatic Mini-
Processor (DP-1VR), which is sold separately. When connecting, connect the
Digimatic cable to the RS_LINK connector (OUT) of the Counter.
Tips
• A maximum of 6 digits can be printed. When Counter displays the value in 7 or 8 digits,
the last 6 digits will be printed. For example, when "12.34567 mm", which has 7 digits, is
output, it will be printed as "2.34567 mm".
• Set the DP-1VR to compatible mode. For details about the setting method and operations,
see the User's Manual for DP-1VR.
5.2
USB Communication Function
By installing SENSORPAK (Mitutoyo product) on a PC, you can load
measurement data from a Counter to the PC by connecting the Counter to the
PC with a USB connecting cable (A-B type). A USB connecting cable is not
supplied. You must provide one.
Tips
• The USB port for communication with SENSORPAK.
• For details about SENSORPAK, see the SENSORPAK User's Manual.
To Next Page
Loading...