63
No. 99MAH056A
5 Setting Parameters
(Short press) / (Long press)
■Functions that can be assigned to each key
[F1] key [F2] key [F3] key
[nonE]
None
[nonE]
None
[nonE]
None
[unit]
Unit switching
[ZEro]
Zero setting
[hoLd]
Display value hold
[dir]
Count direction switching
[ P.C A LL]
Preset recall
*1
[dir]
Count direction switching
[grAd]
Analog bar scale
switching
—
[grAd]
Analog bar scale
switching
[A.ctr]
Analog bar centering
*2
—
[A.ctr]
Analog bar centering
*2
*1: Set the measurement origin by replacing the display value with the preset
value.
*2: By setting the analog bar scale, move the pointer display position to the
center of the scale when the pointer is out of the display range, etc.
To Next Page
Loading...
