Mitutoyo QM-Height QMH-24"BX - Page 17

3
1 Before Using This Product
No. 99MAF600B
Number Name Functions
③
Probe unit Unit that detects the position of the measuring surface. The
ball on the tip of the stylus is brought into contact with the
measuring surface, and then the ball is pressed against the
measuring surface to detect the position.
④
Air-oatswitch(QMH-600BX/
QMH-350BX/QMH-24"BX/
QMH-14"BX only)
Thisswitchusestheair-oatfunctiontoraisethemainunit
of the product.
Donotexecuteameasurementwiththeair-oat
function active because a measurement error may
occur.
⑤
Carrier grip Gripped when moving the main unit on the surface plate.
⑥
Label Contains information such as the code number of this product.
⑦
Base Is in contact with the surface plate when the main unit is
installed. Held when moving the main unit on the surface
plate.
⑧
Micro USB connector
(A/B receptacle)*
Port for connecting a PC with a USB micro A-cable.
⑨
Digimatic output connector* Port for connecting the Digimatic mini-processor (DP-1
series, optional accessory).
⑩
DC jack* Jack for connecting an AC adapter (optional accessory).
⑪
Battery case Case for inserting the batteries.
⑫
Probe unit up/down wheel When turned, moves the probe unit up and down.
Slowly turn the wheel to avoid malfunction.
⑬
Probeneadjustmentknob Moves the probe unit slowly when pulled and turned.
⑭
Clamp screw Fixes the rotational movement of the probe unit up/down
wheel.
⑮
Float amount adjustment screw
(QMH-600BX/QMH-350BX/
QMH-24"BX/QMH-14"BX only)
Adjuststheamountofairowwhentheair-oatfunctionis
active.Turningitclockwiseincreasestheairow(amountof
theair-oatow),andturningitcounterclockwisedecreas-
estheairow.
⑯
Clamp knob Fixes the free vertical movement of the probe unit itself.
Tips
• Loosen the knob when using the probe normally.
• Tighten the knob when using a lever-type dial gauge (op-
tional accessory).
⑰
Holder Used to mount and secure the stylus.
Tips
A lever-type dial gauge (optional accessory) or dial gauge
(optional accessory) can be mounted instead of the stylus.
⑱
Stylus The ball on the tip is brought into contact with the work-
piece to perform measurements.
⑲
Holder clamp knob Secures the inserted holder.
* During use, we recommend securing the cable part with the supplied cable clamp.