Mitutoyo QM-Height QMH-24"BX - Registering the Order of Measurements

45
3SpecicUsageApplications
No. 99MAF600B
3.4 Registering the Order of Measurements
"Perform measurements in the following order: height at four points, inside diameter at four points, and
outside diameter at two points." When performing measurements with a combination of multiple items
inasetorder,itisbenecialtoregistertheorder.Becausethemeasurementitemsareautomatically
performedintheregisteredorder,theoveralloperationissimplied.
There is one type of order that can be registered including up to 10 of the following measurement items.
▪Bottomsurfacemeasurement
▪Topsurfacemeasurement
▪Insidediametermeasurement
▪Outsidediametermeasurement
▪Planescanningmeasurement
Tips
For details about each measurement item, see "3SpecicUsageApplications"onpage33.
Register up to 10 measurement items such as for height or inside diameter in the order to be measured.
1
Press [MODE] twice.
» Characters will be displayed in the bottom row of the LCD.
2
Press [ZERO/ABS] to select [ASSIST] (assist function).
M1 M2
» The registered steps will be displayed.
If no steps are registered If steps are registered
3
Ifstepsareregistered,press[←], and select [ENTER STEP], and then press [ENTER].