How to change throttle mode:
Step t Keep pressing the red button and turn on the remote controller, the remote controller is under
signal connection status (indicated as pic.1);
Step 2. Keep pressing the RTH button "
for 3 seconds to choose the throttle control mode (indicated
as pic.2). The throttle control mode will change according to each press. The mode number is
shown on the LCD screen. The throttle control mode is set at mode 2 by default.
Pic. 1
Pic. 2
Attention: To change the stick mode of the remote controller, please make sure that the
remote controller is under signal connection status (the indicator light keep
flashing). If not, the stick mode could not be changed.
Remote controller control stick calibration
Step t Keep pressing the red locking button and turn on the remote controller (indicates:: as pic.1);
Step 2. Press the calibration button for 3 seconds, the remote controller will male 3 !:)eep sounds and
the indicator light of the remote controller turns from flashing quickly to slowly. Maximum rotate
both of the left and right control stick to any direction for 2 circles {indicates.: as pic.2);
Step 3. Then, again, press the calibration button for 3 seconds (indicated as pic.3). The 1
-
emote
controller will send out 3 beep sounds and the indicator light of the remote controller turns from
flashing slowly to quickly, which means that the control stick calibration is completed.
Pic. 3
Pic_ 1
Pic. 2
Warm tips: All remote controllers have been calibrated when manufacturing.
Remote controller calibration is requested only if pilots find that the remote
controller control sticks are not working normally.
Attention: Please do not power on your aircraft when calibrate the control stick for the
remote controller.
To Next Page
Loading...
