Adjusting Unit of Measure: Celsius and Fahrenheit
• Press and then hold the ‘SET’ button until you see the screen Flash ‘F1’.
• On the top right corner, you will see either ‘F’ or ‘C’ flashing. This is the unit the thermometer is
currently recording measurements.
• To change the unit of measurement please press and release the “MEMO” button once to switch to
the alternative unit. The newly selected unit will be displayed on the screen.
• Once you have selected the appropriate unit, please press and release the ‘SET’ button to save the
selection.
• Lastly, press the power button to return to the home screen, you will see the new unit of measure
selected displayed on the screen.
Adjusting Sound: ON/OFF
• To turn the sound on/off press and release the ‘SET’ button. ‘ON’ or ‘OFF’ will display on the screen
depending on the current setting.
• If sound is turned ‘ON’ device will ‘beep’ and display sound icon on the screen.
Measurement Preparation For Best Results
• For more accurate measurements always store the device in same environment it is being used, for
at least 30 minutes prior. An unexpected fluctuation of ambient temperature is likely to lower
measuring accuracy.
• External factors may influence forehead temperatures, particularly when the individual has been:
o Exposed to very hot or cold temperatures.
o Recently exercising, bathing or other physical exertion as this increase’s temperature.
• Do not talk or move body during measurement.
• Make sure to dry forehead or excessive hair may cause inaccurate reading.
• The infrared sensor must be kept clean, dry and undamaged to ensure accurate results. Please wait
5-15 minutes before taking measurement again.
• Replace battery when low battery indicator is “ON”.
• Use of this device is not intended as a substitution for consultation with your physician.
Measurement results are for reference only. Contact your physician if you have or suspect and
health concerns.
To Next Page
Loading...
