FR35 AC/DC Disposal
17
9Disposal
➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
The DC outlet is dirty.
This results in a poor
electrical contact.
If the plug of your cooler becomes
very warm in the DC outlet, either the
DC outlet must be cleaned or the
plug has not been assembled
correctly.
The fuse of the DC
plug has blown.
Replace the fuse in the DC plug, see
chapter “Replacing the plug fuse
(12/24 V)” on page 15.
The DC fuse inside
the device has blown.
This can only be repaired by an
authorised repair centre.
The vehicle fuse has
blown.
Replace the vehicle’s DC outlet fuse.
Please refer to your vehicle’s operat-
ing manual.
The display shows
an error message
(e. g. “Err1”) and the
appliance does not
cool.
The appliance has
switched off due to an
internal fault.
This can only be repaired by an
authorised repair centre.
Fault Possible cause Suggested remedy
Mobicool_FR35-B-16s.book Seite 17 Donnerstag, 18. Oktober 2018 10:47 10
To Next Page
Loading...
