Cleaning and maintenance FR35 AC/DC
16
7 Cleaning and maintenance
!
A
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
8 Troubleshooting
WARNING!
Always disconnect the device from the power supply before you
clean and service it.
NOTICE! Risk of damage
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
Fault Possible cause Suggested remedy
Device does not
function, LED does
not glow.
There is no voltage
present in the 12/24 V
socket in your vehicle.
In most vehicles the ignition must be
turned on before power will be sup-
plied to the DC power outlet.
The device does not
cool (plug is inserted,
“POWER” LED is lit).
Defective compressor. This can only be repaired by an
authorised customer services unit.
The device does not
cool (plug is inserted,
“POWER” LED
flashes orange, dis-
play is switched off).
Battery voltage is too
low.
Test the battery and charge it as
needed.
Mobicool_FR35-B-16s.book Seite 16 Donnerstag, 18. Oktober 2018 10:47 10
To Next Page
Loading...
