MCG15 Operation
11
6.3 Connecting the cooler
Using the fused DC plug
A
➤ Plug the DC connection cable into the DC voltage socket of the cooler
(fig. 3 1, page 3).
➤ Connect the connection cable to a DC power outlet.
Connecting to an AC power supply
D
➤ Plug the AC connection cable into the AC voltage socket of the cooler
(fig. 3 6,page 3).
➤ Connect the connection cable to an AC power outlet.
6.4 Using the battery monitor
A
NOTICE! Damage hazard
Failure to obey this instruction may result in damage to the device.
For protection of the device the DC cable supplied includes a
fuse inside the plug. Do not remove the fused DC plug.
Only use the DC cable supplied.
Disconnect the cooling device and other consumer units from
the vehicle battery before you connect the vehicle battery to a
quick charging device.
Overvoltage can damage the electronics of the cooling device.
DANGER! Electrocution hazard
Failure to obey these warnings will result in death or serious injury.
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
If you are operating your cooler on board a boat from a AC
power supply, you must install a residual current circuit breaker
between the AC power supply and the cooler.
Seek advice from a trained technician.
NOTICE! Damage hazard
Failure to obey this instruction may result in damage to the battery.
When switched off by the battery monitor, the battery will no longer
be fully charged. Avoid starting repeatedly or operating current
consumers without longer charging phases. Ensure that the battery
is recharged.
MobicoolMCG15_OPM_4445103306_EMEA16_202x-xx-xx.book Seite 11 Freitag, 16. April 2021 2:17 14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
