Operation MCG15
12
The device is equipped with a multi-level battery monitor that protects your
vehicle battery against excessive discharging when the device is connected
to the on-board DC supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler
switches off automatically as soon as the supply voltage falls below a set
level. The cooler will switch back on once the battery has been recharged to
the restart voltage level.
6.5 Using the cooler
A
➤ Place the cooler on a firm foundation.
I
➤ Connect the cooler (chapter “Connecting the cooler” on page 11).
✔ The cooler starts cooling the interior.
A
Switch-off voltage at 12 V
11 V
Restart-voltage at 12 V
12 V
Switch-off voltage at 24 V
21.5 V
Restart voltage at 24 V
23.0 V
NOTICE! Damage hazard
Failure to obey this instruction may result in damage to the device.
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate. We recommend keeping a gap of at least 50 mm
around ventilation holes.
NOTE
Place the cooler as shown (fig. 1, page 3). If you operate the
cooler in a different orientation it can be damaged.
NOTICE! EXCESSIVELY LOW TEMPERATURE HAZARD
Failure to obey this instruction may result in damage to the objects
placed in the cooler.
Ensure that only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
MobicoolMCG15_OPM_4445103306_EMEA16_202x-xx-xx.book Seite 12 Freitag, 16. April 2021 2:17 14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
