MobileView 7000 Series User Manual 33
Wireless Settings
The device supports a radio frequency (RF) option module. When installed, the RF option card
enables wireless communications in client mode. Supported transmit options and security modes
depend upon the specific wireless card included with the RF option module. These are automatically
set when the card is detected during system boot.
WPA Security Modes
The system supports WPA1 and WPA2 personal security modes. To enable advanced, enterprise-level
wireless security, Third party specialty wireless equipment must be added to the system and
connected to the rear network.
Client Settings
Use the wireless client settings to set the configuration settings for wireless client basic settings,
security settings, and network settings.
1. Click Network.
2. Click Wireless Client.
3. Make necessary changes in the Client Settings group.
Wireless Network Mode: Select the wireless network mode for the AP. Choose from
Disabled, Auto, Mixed (2.4GHz Only), and Mixed (5GHz Only).
Wireless SSID: Enter the wireless SSID for the AP.
Wireless Channel: Select the wireless transmission channel for the AP.
Channel Width: Select the wireless transmission channel bandwidth for the AP.
Security Mode: Select the wireless security mode for the AP.
WPA Algorithms: Select the encryption method to use with the selected security mode on
the AP.
Shared Key: Enter the security key to use with selected security mode.
Unmask Key: Check the box to see the shared key. Uncheck the box to replace characters
with *.
Network Type: Select the wireless network mode.
Survey: Click Survey to open a new browser window containing a wireless survey.
4. Click Apply.
Wireless Survey
When equipped with a wireless card, the device supports basic wireless survey capabilities. Pressing
the Survey button opens a dialog displaying information about nearby access points. Highlight the
desired row and press Select to automatically populate client wireless settings.
To Next Page
Loading...