Mobiltech ZEUS200 - Page 23

Zeus200 Installation manual
V 1.0.7 - 12/10/2020 Page 23 of 28
The setting of the secondary battery type (engine), if connected to the system, takes place using
the first two switches, as described in the following table.
Position
1
2
Description
@ 12V
@ 24V
OFF
OFF
Lead
Hermetic/Agm/
Gel (SEAL)
Secondary
Battery
EE_VEoCBatt2=1
14,2V @25°C
temperature
compensated
28,4V @25°C
temperature
compensated
EE_VlowBattery2=17
12,2V
24,6V
ON
OFF
Lead Acid Free
(FLOOD)
Secondary
battery
EE_VEoCBatt2=0
14,8V@25°C
29,6V@25°C
EE_VlowBattery2=17
12,2V
24,6V
OFF
ON
LiFePO4
Secondary
battery
EE_VEoCBatt2=6
14,2V –no
temperature
compensated
28,4V –no
temperature
compensated
EE_VlowBattery2=22
12,8V
25,6V
ON
ON
Not allowed:
same settings
as SEAL
battery
-
-
Now the generator is ready to be used.
Activate the automatic or manual mode as described in the user manual.
Installation notes:
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________