23
MOBIUSTRIMMER.COM
OPERATION PREP
Please take the following steps to conrm that Mobius Trimmer M108S is ready to operate:
1. Complete a thorough inspection of the blades and tumbler following the 6-Point Blade Inspection
steps to ensure that the blades are seated properly.
2. Check that the electrical box lter is in place and clean.
3. Conrm that the power cord is in good condition and locked into the machine power receptacle.
4. Ensure all guarding is properly installed and is in good working condition.
5. Address any errors that are agged on the control panel.
GENERAL OPERATION
PRIOR TO DEVICE OPERATION, ENSURE ALL GUARDS ARE IN PLACE AND PROPERLY SECURED.
PRESS THE E-STOP BUTTON AT ANY TIME TO STOP ALL MOVING PARTS AND TURN OFF THE MACHINE.
GETTING READY TO TRIM
1. Identify a Trim Team Lead. This person is responsible for:
2. Identify roles for each of the trim team members. Typical roles could include:
3. Put the infeed and outfeed equipment into place. If using conveyors, ensure they are adjusted
to the correct height. For the outfeed conveyor, this means setting it at a height below the
outfeed of the trimmer. For the infeed conveyor, this means setting it at a height that has the
belt just touching the infeed conveyor guide when the tilt angle is at the lowest level you will
be operating at. It is ok if the lead legs on the infeed conveyor lift off the oor when the tilt
angle is increased
• Ensuring that the trimmer is set-up correctly and all pre-start inspections have taken place;
• Ensuring that appropriate PPE is available and utilized by all team members in the room;
• Assigning trim team roles, as per item 2 below;
• Operating the trimmer and dialing in the key variables angle, feed rate and vacuum) until
the desired level of trim is reached on the outfeed. *Note, a change to any one of the key
variables will take a period of time to show on the output quality
• Feeding the trimmer via the infeed conveyor or infeed hopper;
• Performing QC and polishing of material on the outfeed conveyor or outfeed tote;
• Acting as a runner, which includes bringing totes of untrimmed material to the infeed line,
changing out full totes for empty totes on the outfeed line, keeping and eye on and swapping
out the trim tote when full, weighing material, as required, etc.
To Next Page
Loading...