Mobius Trimmer M108S - WET TRIMMING

27
MOBIUSTRIMMER.COM
• VFDs:
Blades: at full power (11)
Vacuum: at full power (11)
Tumbler: at full power (11)
• FEED RATE:
If using conveyors, you will likely run in the range of 10 – 20 on the infeed conveyor
speed dial. Adjust up or down as necessary to achieve desired trim quality. If using an
infeed hopper, aim to maintain a consistent feed rate once the desired trim quality has
been dialed in.
• TILT ANGLE:
Start with caster at the infeed end of the line approximately 1/2” off . Over the rst few
minutes of trimming, play with the tilt angle, only increasing to the point where it does
not compromise trim quality below your requirements.
• TUMBLER FILL:
When wet trimming, there is no need to rapidly prime the tumbler (unlike dry trimming)
but it is important to maintain the tumbler at approximately 3/4 full.
• VFDs:
Blades: at full power (11)
Vacuum: at full power (11)
Tumbler: at full power (11)
• FEED RATE:
If using conveyors, you will likely run in the range of 20 – 40 on the infeed conveyor
speed dial. Adjust up or down as necessary to achieve desired trim quality. Use of
an infeed hopper is not recommended for a tandem Mobius set-up as it is difcult to
maintain a consistent, high feed rate.
• TILT ANGLE:
Start with casters at the infeed end of the line approximately 2” off the oor. Over the
rst few minutes of trimming, play with the tilt angle, only increasing to the point where
it does not compromise trim quality below your requirements.
• TUMBLER FILL:
When wet trimming, there is no need to rapidly prime the tumbler (unlike dry trimming)
but it is important to maintain the tumbler at approximately 3/4 full.
SINGLE MOBIUS UNIT
TANDEM MOBIUS LINE
When wet trimming with a single Mobius unit, try starting with the following parameters and adjust as
necessary to reach the desired trim quality:
When wet trimming with a tandem Mobius line, try starting with the following parameters and adjust as
necessary to reach the desired trim quality
WET TRIMMING