MOBIUS TRIMMER M108S USER GUIDE
32
CLEANING
While the body of the Mobius Trimmer cannot be power washed, many of the components can be.
Once the removable parts are out of the machine, the body and lid can be washed and wiped as
needed. The lid can be wiped down while installed on the body or removed for cleaning. The exterior
should never be hosed or sprayed. Evidence of water near the motor, conduit, electrical panel, or
gearbox could void the machine warranty.
Appendix B contains a chart with cleaners and procedures we recommend to ensure your components
are optimally maintained and therefore extending the life of your equipment.
PREVENTATIVE MAINTENANCE
PERFORM BEFORE EACH USE (MOBIUS LEAD):
PERFORM AFTER EACH USE (MOBIUS LEAD):
1. Check tumbler condition. Ensure wires are not kinked or frayed. Ensure rings and end caps are
ush and sealed. Ensure tumbler has been stored properly before use (i.e. that is has been stored
in a plastic bag with water).
2. Check trim tote gasket condition. Ensure gasket is not damaged and is securely attached to trim
tote all the way around the rim.
3. Check trim tote condition. Trim tote should be rectangular (not bowed or distorted) and should
not have any cracks or tears.
4. Check helical blades, bed knives
and spacer bars to ensure there is no
damage (i.e. no nicks on the cutting
edges or gouges on the body of each
of these parts). Ensure dowel pin is in
place.
5. Check brush to ensure there is no damage to bristles.
6. Ensure a clean e-box lter is installed
1. Thoroughly clean all plant-touching parts and place parts in an orientation that ensures that
they drain and dry completely.
2. After rinsing the tumbler, store it wet in a plastic bag until next use. This will maintain the exibility
of the tumbler rings and end caps.
NOTE: PERFORM THESE STEPS WITH THE MACHINE UNPLUGGED
!
To Next Page
Loading...