is not clogged. If air cannot easily flow through the filter, the strength of the
vacuum created by the machine is diminished and trim quality will suffer.
4. Confirm that the power cord is in good condition and that the twist lock plug ends
are locked into the machine power receptacle and the power source.
5. Ensure all guarding is properly installed on the trimmer and on any other
accessories and/or machines being used in conjunction with the trimmer.
6. Ensure that the tumbler and all blade components are in good condition and
properly installed in the machine. Carry out the 6-Point Blade Inspection before
starting the machine.
7. Ensure that the separator is properly assembled and installed and that the trim
tote(s) and gasket(s) that will be going into operation are in good condition and
properly installed.
8. Address any errors that are flagged on the control panel.
GENERAL OPERATION
PRIOR TO DEVICE OPERATION, ENSURE ALL GUARDS ARE IN PLACE AND PROPERLY
SECURED. PRESS THE E-STOP BUTTON AT ANY TIME TO STOP ALL MOVING PARTS AND
TURN OFF THE MACHINE.
GETTING READY TO TRIM
1. Identify a Trim Team Lead. This person is responsible for:
● Ensuring that the trimmer is set up correctly and all pre-start inspections have
taken place;
● Ensuring that appropriate PPE is available and utilized by all team members in
the room;
● Assigning trim team roles, as per item 2 below;
● Operating the trimmer and dialing in the key variables (feed rate, tilt angle,
tumbler speed, vacuum, and blades) until the desired level of trim is reached
on the outfeed.
Note: There is a delay between making a change to one or more of these
variables and seeing the impact of that change on the buds coming out of the
trimmer. Be patient when dialing in the trimmer settings so as not to
over-correct.
MOBIUS M108S USER GUIDE 18
To Next Page
Loading...
