TILT ANGLE
Start with casters at the infeed end of the line approximately 3” off the floor. After the
tumblers have been primed and the feed rate has been dialed in for trim quality, adjust the
tilt angle up or down to maintain the tumblers at 65% - 75% full.
FEED RATE
As the tilt angle is adjusted the feed rate will also need to be adjusted to maintain the 65% -
75% fill level in the tumblers. If the tilt angle is increased, the feed rate will also increase. If
the tilt angle is decreased, the feed rate will also decrease.
WET TRIMMING: SINGLE M108S UNIT
When wet trimming with a single M108S Trimmer, try starting with the following
parameters and adjust as necessary to reach the desired trim quality:
VFDs
Blades: At full power (11)
Vacuum: At full power (11)
Tumbler: At full power (11)
TUMBLER FILL
When wet trimming, there is no need to rapidly prime the tumbler (unlike dry trimming)
but it is important to maintain the tumbler at approximately 50% – 65% full.
Because it can be difficult to tell how full the tumbler is when it is spinning, observe how
much of the blades are covered by plant material. When the tumbler is properly filled, the
two blades towards the front of the machine will be completely covered and most of the
back blade, save the 6 to 12 inches closest to the infeed, will also be covered. The tumbler fill
level will taper off in a similar way at the outfeed.
TILT ANGLE
Start with casters at the infeed end of the line approximately 1” off the floor. After the
tumbler has been primed and the feed rate has been dialed in for trim quality, adjust the
tilt angle up or down to maintain the tumbler at 50% - 65% full.
FEED RATE
As the tilt angle is adjusted the feed rate will also need to be adjusted to maintain the 50% -
65% fill level in the tumbler. If the tilt angle is increased, the feed rate will also increase. If the
tilt angle is decreased, the feed rate will also decrease.
MOBIUS M108S USER GUIDE 26
To Next Page
Loading...