English 22
- Make sure the air hole at the front and the back part of the drying machine (dryer) is not closed.
- The back part of the drying machine (dryer) will be very hot when it is turned on.
- Make sure the back part of the drying machine (dryer) is hard to be reached when the machine is
operating.
- Do not use connecting cable. The plug on the drying machine (dryer) must be connected directly
to the outlet.
- Install the filter on its place.
- Put the drying machine (dryer) where the outlet can easily be reached after installation.
- Clean the drying machine (dryer) (outside & inside part) from dust/dirt with moist fabric.
- Smell from the heater will disappear after the first period of heating.
Attention:
The drying machine (dryer) must be connected to the electrical source which has been connected to
the ground / grounding.
Water Output (ED 850)
Condensed water is not always needed to be thrown away to the
tank, if possible, the condensed water can also be drained
directly.
To change the direction of the water output pipe, it can be done
by pulling the water pipe according to the arrow direction (Look
picture A). Then install the output pipe.
Setting the height
1. Set the unit height to prevent vibration and noise. The machine must be set at a clean place and
free from combustible materials, water and ice. To reduce vibration and noise when the unit is
used, the unit must be placed on a flat and strong surface.
2. To set the height, it can be done by rotating the front part of the leg: for
lowering, it can be done by rotating the leg counter-clockwise. To heighten
it, do the opposite rotation until the unit is not vibrating anymore when it is
used.
3. After the height adjustment is done, check the unit balance by pressing
each corner of the upper cover, if it is still unsteady, that means the unit still
need adjusting.
4. Do not put pile of towels at the floor close to the unit, because it can cause
heat and disturb the unit performance
IMPORTANT: Heat is emitted by the drying machine at a temperature that can reach 60
0
C. Make
sure the unit is placed on the floor that can bear high temperature. When operating the unit, the room
temperature must not be lower than 5
0
C and higher than 35
0
C because it will affect the drying
performance.
Electric Connection
Every work that is connected with the electric in this unit installation must be done by experienced and
professional technician.
Warning: This unit must be grounded
The producer is not responsible for every form of damage and loss that is caused by not following the
safety guidance that has been given.
Before activating the unit, make sure that the electric supply is in accordance with unit specifications.
If the outlet needs to be changed, follow the explanation below.
The Color of the cable at the power cable shows code as the following:
Green and Yellow – Earth / Grounding
Blue – Neutral
Brown – Live
To Next Page
Loading...