English 29
Lint Filter (ED 650):
Clean the lint filter after every drying finish.
Filter (ED 850):
- Clean the filter after every drying finish.
- The dryer will function properly only if the filters in a clean
condition.
- To ensure an effective working unit, the filter will filter and collect
yarn and fiber clothes during the drying process takes place.
- Indicator lights "Filter" function to remind you, that the filter
should be cleaned.
- For cleaning the filter should be removed.
- When drying, there is a detached fiber clothes, dryer (dryer) through the filter will capture and
collect the fibers.
- When the above happens, use a brush and warm water to clean the filter. Open the door and
remove the filter (see picture)
Doors:
periodically clean the inside of the door (especially ED 850) to
eliminate yarn and clothing fibers. Hygiene affects the effectiveness of
the drying process.
Warning: Dryer (dryer) must be used with the filter.
Emptying the water container (ED 850):
Water container holds all the water from the condenser. The water container needs to be emptied
after each use. If it will not decrease the performance of work dryer (dryer). If the water reservoir is
full, the indicator light will illuminate when the drying process takes place, and sound an alarm /
buzzer will sound. In this situation, the water reservoir must be emptied in an hour.
1. Pull the water container
2. Cleaning out the water
Cleaning out the water condenser (ED 850):
The condenser is a very important part in the process of drying. Thus requires special attention. It is
recommended that you clean the condenser three or four times a year.
1. Open the closure of the condenser.
2. Open two pairs of lock, then pull out the
condenser.
3. To clean the condenser, condenser put under the tap and flush the
water make sure all parts of the condenser is cleaned.
4. Follow the instructions above in reverse to install the condenser.
To Next Page
Loading...