Need help?Do you have a question about the Moduline Select Series and is the answer not in the manual?
Prepare the base cabinet door assembly by placing it on foam for protection.
Secure both side panels to the main door assembly for the base cabinet.
Connect the top braces to the side panels of the base cabinet structure.
Fasten the rear horizontal supports to the side panels of the base cabinet.
Connect the front toe kick piece to both side toe kick components.
Attach the rear toe kick piece to the side toe kick components.
Place the main cabinet body onto the assembled toe kick and attach loosely.
Position and attach the shelf into the base cabinet's door frame.
Slide the bottom pan into its designated slots within the toe kick assembly.
Prepare the closet door assembly by placing it on foam for protection.
Secure both side panels to the main door assembly for the closet.
Connect the top panel to the side panels of the closet structure.
Fasten the rear horizontal supports to the side panels of the closet.
Connect the front toe kick piece to both side toe kick components.
Attach the rear toe kick piece to the side toe kick components.
Place the main closet body onto the assembled toe kick and attach loosely.
Position and attach the shelf into the closet's door frame.
Slide the bottom pan into its designated slots within the toe kick assembly.
Secure the light shield to the underside of the overhead cabinet unit.
Connect matching Instant Wall panels using stiffeners on both sides of the joint.
Insert the specified cage nuts into the rear of each Instant Wall panel section.
Bolt panel sections together with stiffeners, assembling corners with angles.
Adjust anchor bracket length by bending or bolting sections as needed for wall fitting.
Hook brackets into wall panels and secure to the wall using appropriate hardware.
Place the first cabinet, loosen toe kick bolts, and use shims for leveling.
Position the next cabinet and loosely bolt it to the previously installed units.
Continue the process by repeating steps 1 and 2 until all components are installed.
Secure the countertop brace to adjacent cabinet bases or toolboxes.
Use the brace as a template to drill mounting holes in the closet side, ensuring level placement.
Bolt the main corner filler piece and the toe kick filler together.
Secure the joined corner filler to adjacent cabinet bases or toolboxes.
Insert bolts into the top-rear holes of the corner filler sides for the countertop brace.
Slide the countertop brace down onto the previously installed bolts.
Tighten bolts to ensure the brace is level and flush with adjacent cabinet tops.
Drill holes in the countertop brace for securing it to the wall.
Fasten the countertop brace to the wall using suitable mounting hardware.
Apply double-sided tape to cabinet tops and braces where the countertop will be placed.
Before removing tape backing, test fit the countertop to ensure correct placement.
Remove tape backing and spray with window cleaner for easier adjustment.
Carefully place the countertop onto the taped surface and allow it to dry.
General| Brand | Moduline |
|---|---|
| Model | Select Series |
| Category | Indoor Furnishing |
| Language | English |
To Next Page
