Modulus Arms AR-15 - Required Tools

www.ModulusArms.com
March 25, 2015
www.ModulusArms.com | AR-15 Jig Instructions
3
Required Tools
The following items are required to finish the 80% AR-15 Lower Receiver:
(Available for sale on Modulus Arms Website)
1. ¼” Dia, ¼” Shank, 4” Long, 1” Cut, Square End Mill
2. 3/8” Drill Bit
3. 19/64” Drill Bit
4. 5/32” Drill Bit
5. 3/8” Drill Stop
Figure 2: Jig Fabrication Kit
The additional tools needed to finish the 80% AR-15 Lower Receiver:
1. Router (Laminate/Trim Recommended)
2. Front Takedown kit or ¼” bolt
3. Drill (Hand or Drill Press)
4. 1/8” Allen Wrench
5. Vise or device to hold Jig
6. 9/64” Allen Wrench
7. Phillips Screwdriver
8. 3/16” Allen Wrench
Figure 3: Example Tools
Routers that we recommend to finish the 80% AR-15 Lower Receiver:
1. Ridgid R24012
2. Dewalt D26670
3. Makita RT0701C
4. Porter-Cable PCE6430
5. Porter-Cable 7310